// Changes made in LynxBatch Software Release "B.1":
// "LB970319" version:
Corrected material file dribble, preact and inventory entry for integer builds.
(These were corrupted in the LB970314 changes.)
// "LB970314" version:
Corrected Discharge target value.
Corrected calibration and shift adjust cursor rotation.
Corrected Rate slow timer operation.
Corrected "StopFeed?Y" operation when previous recipe line was within tolerance.
Corrected capacity entry display positioning.
// "LB970306" version:
Return to gross weight display if no keyboard tare entry within 5 seconds.
Return to net weight display after 5 seconds of Gross/Tare recall display.
Restore Gross and Tare cursor display when corresponding weight is being recalled.
// "LB970303" version:
Added "StopFeed?Y/N" setup parameter to stop the material feed and proceed with recipe execution when
a '*RateSlow' condition occurs during a Weigh Out operation if the delivered material is within tolerance.
Auto-detection of MELSI2/WTC200 chip.
Corrected storage and recall of material settle time and jog time.
// "LB970219" version:
Automatically clear batch tare.
Enable clear button during batching ignoring any tare clear only at gross zero interlock.
Add "Audit On?Y/N" prompt to end of "Data Corr" setup menu.
If this parameter is selected to On, printing will occur between "Print On" and "Print Off" action codes
whenever a Weigh In, Weigh Out, Manual Weigh, or Hand Add operation is completed.
If Accept off Tolerance is disabled prompt "Resume?Y/N", "Save? Y/N" and "Abort?Y/N" instead of "Accept Y/N".
Com1 XON/XOFF flow control as default. (Was "None".)
Com1 no input connection as default. (Was "Command")
Enable keyboard entered tare during batching (manual weigh) when tare and/or keyboard entered tare is disabled.
Change to update dispaly cursors during prompt display to show gross/net and setpoint status during batching.
// "LB970208" version:
If weight within tolerance at "*Rate Slow" alarm finish batch.
If Accept off Tolerance is disabled do not prompt Accept Y/N. (display "Over Tol.!" or display "Under Tol.!" instead).
Automatically clear tare at "Order Done" display.
// "LB970206" version:
Corrected "Mat Tgts?Y" operation during weigh-out.
(Previously did not ask for entries after "Mat Tgts?Y" entered).
Corrected 4-digit century rollover from '1999' to '2000' (was '1900').
Update "Software ID" with Flash value.
Eliminate template 2 clear causing delete on template 1 pointer that causes crash upon entering setup.
// Release "B.0" changes:
Added backdoor password.
Removed non-functional external scale feature.
// Release "A" changes: